 |
| pict : graphicproducts.com |
Procedure Electrical Safety
- Only trained and authorized employees may conduct repairs to electrical equipment.
- Individuals performing work on energized electrical circuits must hold appropriate qualifications and be specifically authorized to perform such work.
- Electrical distribution areas must be guarded against accidental damage (e.g. specifically designed rooms, using substantial guard posts and rails, etc.).
- Access to electrical distribution rooms must be restricted to authorized employees.
- All electrical distribution panels, breakers, switches and junction boxes must be completely enclosed and protected from wet conditions.
- All electrical control devices must be labeled to identify the equipment controlled.
- All distribution panels must have 0.9 meter (3 feet) clearance.
- All conduits must be fully supported throughout their length. Non-electrical attachments to a conduit are prohibited.
- All electrical wiring and cables must be in good condition (no exposed circuits).
- Extension cords must be used on temporary basis only.
- Ground Fault Circuit Interruption (GFCI) must be provided for wet locations.
- Site specific electrical safety rules must be available.
Electrical Inspections:
- Facility must have an Inspection and testing schedule.
- The frequency of these inspections depends on the local country regulations, type of equipment, the environment it is used in and the frequency of use.
- Major modifications to new and existing facilities must be inspected to verify compliance with codes and standards.
- Process for prioritizing and correcting electrical deficiencies.
Protective Equipment (for work on energized circuits):
- Electrical-rated safety shoes/boots and goggles must be worn as required per risk assessment.
- All tools used for electrical work must be properly insulated.
- Electrical-rated matting must be installed in front of all distribution panels in electric utility rooms.
